History

Ryan ebb512db82 Debounce defines cleanup (#19742 ) * Clean up `DEBOUNCE` in config.h, 0-9 * Clean up `DEBOUNCE` in config.h, A * Clean up `DEBOUNCE` in config.h, B * Clean up `DEBOUNCE` in config.h, C * Clean up `DEBOUNCE` in config.h, D * Clean up `DEBOUNCE` in config.h, E * Clean up `DEBOUNCE` in config.h, F * Clean up `DEBOUNCE` in config.h, G * Clean up `DEBOUNCE` in config.h, H * Clean up `DEBOUNCE` in config.h, handwired * Clean up `DEBOUNCE` in config.h, I * Clean up `DEBOUNCE` in config.h, J * Clean up `DEBOUNCE` in config.h, K * Clean up `DEBOUNCE` in config.h, L * Clean up `DEBOUNCE` in config.h, M * Clean up `DEBOUNCE` in config.h, N * Clean up `DEBOUNCE` in config.h, O * Clean up `DEBOUNCE` in config.h, P * Clean up `DEBOUNCE` in config.h, Q * Clean up `DEBOUNCE` in config.h, R * Clean up `DEBOUNCE` in config.h, S * Clean up `DEBOUNCE` in config.h, T * Clean up `DEBOUNCE` in config.h, U * Clean up `DEBOUNCE` in config.h, V * Clean up `DEBOUNCE` in config.h, W * Clean up `DEBOUNCE` in config.h, X * Clean up `DEBOUNCE` in config.h, Y * Clean up `DEBOUNCE` in config.h, Z * Remove default debounce from info.json * Migrate non-default debounce to info.json		2023-02-03 19:19:58 +00:00
..
keymaps/default	Fixup bpiphany/ghost_squid (#18842 )	2022-10-25 14:40:40 +01:00
config.h	Debounce defines cleanup (#19742 )	2023-02-03 19:19:58 +00:00
ghost_squid.c
ghost_squid.h	Bathroom Epiphanies Ghost Squid Refactor (#18816 )	2022-10-22 21:48:29 +01:00
info.json	Bathroom Epiphanies Ghost Squid Refactor (#18816 )	2022-10-22 21:48:29 +01:00
matrix.c
readme.md
rules.mk

readme.md

Ghost Squid Controller

This is the firmware for Rev. 20140518 of the Ghost Squid controller by Bathroom Epiphanies, a replacement controller for the Cooler Master Quick Fire XT.

The code was adapted from the BathroomEpiphanies QMK Firmware.

Keyboard Maintainer: QMK Community
Hardware Supported: Ghost Squid
Hardware Availability: 1upkeyboards

Enter the bootloader in 3 ways:

Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
Keycode in layout: Press the key mapped to QK_BOOT if it is available

Make example for this keyboard (after setting up your build environment):

104 key default layout:

make bpiphany/ghost_squid:default

Flashing example for this keyboard:

make bpiphany/ghost_squid:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.